Pages

Sunday, 24 May 2015

erma budi pratiwi

Nama : erma budi pratiwi
No : 13
Kelas : XITIE
Dynamic routing adalah suatu mekanisme routing yamg menggunakan routing protocol untuk menentukan network dan mengupdate routing table .
Routing Information Protocol (RIP) adalah protokol routing dinamik yang berbasis distance vector. RIP menggunakan protokol UDP pada port 520 untuk mengirimkan informasi routing antar router. RIP menghitung routing terbaik berdasarkan perhitungan HOP. RIP membutuhkan waktu untuk melakukan converge. RIP membutuhkan power CPU yang rendah dan memory yang kecil dari pada protocol yang lainnya.
Kelebihan dynamic routing :
a.      Hanya mengenalkan alamat yang terhubung dengan router
b.      Tidak perlu mengetahui semua alamat network yang ada
c.       Bila terjadi penambahan suatu network baru tidak perlu mengkonfigurasi semua router
Kekurangan dynamic routing :
a.      Beban kerja router lebih berat karena selalu memperbaharui ip
b.      Kecepatan pengenalan dan kelengkapan ip table terbilang lama




1.)Router0

Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#int fa0/0
Router(config-if)#192.168.1.129 255.255.255.224
Router(config-if)#ip address 192.168.1.129 255.255.255.224
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int se0/0
Router(config-if)#ip address 192.168.2.13 255.255.255.128
Router(config-if)#clock rate 4800
Router(config-if)#no shut
%LINK-5-CHANGED: Interface Serial0/0, changed state to down
Router(config-if)#exit
Router(config)#router rip
Router(config-router)#network 192.168.1.128
Router(config-router)#network 192.168.2.0
Router(config-router)#exit
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#
%LINK-5-CHANGED: Interface Serial0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
Router#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default, U - per-user static route, o - ODR
       P - periodic downloaded static route
Gateway of last resort is not set
  192.168.1.0/27 is subnetted, 1 subnets
C       192.168.1.128 is directly connected, FastEthernet0/0
     192.168.2.0/25 is subnetted, 1 subnets
C       192.168.2.0 is directly connected, Serial0/0
R    192.168.3.0/24 [120/1] via 192.168.2.113, 00:00:16, Serial0/0
R    192.168.4.0/24 [120/1] via 192.168.2.113, 00:00:16, Serial0/0
Router#
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#ip dhcp pool voice
Router(dhcp-config)#network 192.168.1.128
% Incomplete command.
Router(dhcp-config)#network 192.168.1.128 255.255.255.224
Router(dhcp-config)#default-router 192.168.1.129
Router(dhcp-config)#dns 192.168.1.129
Router(dhcp-config)#exit
Router(config)#ip dhcp excluded-address 192.168.1.129
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#

       
2.)Router1

Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#int fa0/0
Router(config-if)#ip address 192.168.4.50 255.255.255.248
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int se0/0
Router(config-if)#ip address 192.168.2.113 255.255.255.128
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface Serial0/0, changed state to up
Router(config-if)#exit
Router(config)#int se0/1
Router(config-if)#ip address 192.168.3.92 255.255.255.192
Router(config-if)#clock rate 9600
Router(config-if)#no shut
%LINK-5-CHANGED: Interface Serial0/1, changed state to down
Router(config-if)#exit
Router(config)#router rip
Router(config-router)#network 192.168.2.0
Router(config-router)#network 192.168.4.48
Router(config-router)#network 192.168.3.128
Router(config-router)#exit
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#
Router#
%LINK-5-CHANGED: Interface Serial0/1, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/1, changed state to up
Router#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default, U - per-user static route, o - ODR
       P - periodic downloaded static route
Gateway of last resort is not set
R    192.168.1.0/24 [120/1] via 192.168.2.13, 00:00:23, Serial0/0
     192.168.2.0/25 is subnetted, 1 subnets
C       192.168.2.0 is directly connected, Serial0/0
     192.168.3.0/26 is subnetted, 1 subnets
C       192.168.3.64 is directly connected, Serial0/1
     192.168.4.0/29 is subnetted, 1 subnets
C       192.168.4.48 is directly connected, FastEthernet0/0
Router#
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#ip dhcp pool voice
Router(dhcp-config)#network 192.168.4.48 255.255.255.248
Router(dhcp-config)#default-router 192.168.4.50
Router(dhcp-config)#dns 192.168.4.50
Router(dhcp-config)#exit
Router(config)#ip dhcp excluded-address 192.168.4.50
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console
Router#

3.)Router2
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#int fa0/0
Router(config-if)#ip address 192.168.5.19 255.255.255.240
Router(config-if)#n shut
Router(config-if)#
%LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
Router(config-if)#exit
Router(config)#int se0/0
Router(config-if)#ip address 192.168.3.153 255.255.255.192
Router(config-if)#no shut
Router(config-if)#
%LINK-5-CHANGED: Interface Serial0/0, changed state to up
Router(config-if)#exit
Router(config)#
%LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up
Router(config)#router rip
Router(config-router)#network 192.168.5.16
Router(config-router)#network 192.168.3.64
Router(config-router)#exit
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console

Router#show ip route
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
       D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
       N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
       E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
       i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
       * - candidate default, U - per-user static route, o - ODR
       P - periodic downloaded static route

Gateway of last resort is not set

     192.168.3.0/26 is subnetted, 1 subnets
C       192.168.3.128 is directly connected, Serial0/0
     192.168.5.0/28 is subnetted, 1 subnets
C       192.168.5.16 is directly connected, FastEthernet0/0
Router#
Router>en
Router#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
Router(config)#ip dhcp pool voice
Router(dhcp-config)#network 192.168.5.16 255.255.255.240
Router(dhcp-config)#default-router 192.168.5.19
Router(dhcp-config)#dns 192.168.5.19
Router(dhcp-config)#exit
Router(config)#ip dhcp excluded-address 192.168.5.19
Router(config)#exit
Router#
%SYS-5-CONFIG_I: Configured from console by console

Router#
Posted by Unknown at 22:51
Labels:

0 comments:

Post a Comment